- One bottle replaces up to 32 bottles of the leading anti-bacterial all-purpose cleaner
- Cleans, disinfects and deodorizes
- Concentrated cleaner, sanitizer, fungicide, virucide and mildewstat
- Phosphate free
- Readily biodegradable
- Perfect for bathrooms, kitchens, hospitals, pet kennels, nursing homes, athletic/recreational facilities, food service establishments and much more!
- EPA-registered disinfectant*
*EPA Reg. No. 1839-95–68709; EPA Est No. 55948-NC-01
Snap™ Disinfectant Cleaner
Clean, deodorize and disinfect a variety of surfaces with Snap Disinfectant Cleaner. This phosphate-free cleaner is designed for use in food service establishments, hotels and motels, nursing homes, hospitals and more. It is an EPA-registered product and helpful in preventing cross-contamination in both commercial facilities and homes. Since this disinfectant cleaner is a concentrated solution, one bottle replaces up to 32 bottles of typical anti-bacterial cleaners, saving you money. Snap Disinfectant Cleaner is also a fungicide, virucide and mildew fighter.
Use Snap Disinfectant Cleaner in your bathroom, kitchen, athletic center or anywhere else where germs often accumulate. The formula is biodegradable and phosphate-free. Before using this natural disinfectant cleaner, dilute it to the proper concentration. To clean hard, non-porous surfaces, mix 2 ounces of Snap with 1 gallon of water. This disinfectant also removes mildew and is effective against many organisms, including E. coli, Strep. faecalis and Staph aureus. When you clean with Snap, you deodorize and disinfect at the same time.
Snap Disinfectant Cleaner is a concentrated cleaner, sanitizer, fungicide, virucide and mildewstat that is EPA approved. One bottle of Snap Disinfectant Cleaner can replace up to 32 bottles of the leading anti-bacterial all-purpose spray, over a $100 savings.
Where has Snap been all my life?
Recently, I had the daunting and rather depressing task of cleaning a caked on, dried, greasy mess on the surface of my stove underneath the elements and drip pans. So, I decided to take Snap out for a test drive. I merely added a couple of caps-full to an empty cleaning spray bottle and added water. I sprayed the congealed mess down, waited a few minutes, and wiped the nightmarish mess away with a simple cleaning sponge. For grins, I even finished it off with a paper towel and, I will be darned, that worked too! I can hardly wait to see what else it can do, as well as try other products within the Market America line. So, where has Snap been all my life? As I always say, better late than never!
Cleans very well
The product is concentrated and cleans very well.
smells better than the other products purchased before.
I used it for washing my friends dishes, all the glass ware came out clean, and shinny.
I love this disinfectant. I have two children in the household under three and the disinfectant works well in the wash as well as an all-around multi-use spray on all surfaces. With a medically ill person living in the household, this product is great to help keep the house germ-free as best as we can so that she stays healthy.
How do I use Snap Disinfectant Cleaner?
DISINFECTION: To disinfect inanimate, hard, non-porous surfaces, add 2 ounces of Snap Disinfectant Cleaner per gallon of water. Apply solution with a mop, cloth, sponge, hand-pump trigger sprayer or low-pressure coarse sprayer so as to wet all surfaces thoroughly. Allow to remain wet for 10 minutes, then remove excess liquid. For heavily soiled areas, a pre-cleaning step is required. Prepare a fresh solution for each use.
To disinfect toilet bowls: Flush toilet and add 2 ounces of Snap Disinfectant Cleaner directly to the bowl water. Swab the bowl completely using a scrub brush or toilet mop, making sure to get under the rim. Let stand for 10 minutes and flush.
To disinfect food processing premises: Before using this product, food products and packaging materials must be removed from the area or carefully protected. For floors, walls and storage areas, add 2 ounces of Snap Disinfectant Cleaner per gallon of water. For heavily soiled areas, a pre-cleaning step is required. Apply solution with a mop, cloth, sponge, hand-pump trigger sprayer or low-pressure coarse sprayer so as to wet all surfaces thoroughly. Allow the surface to remain wet for 10 minutes, then removed excess liquid. After use, all surfaces in the area must be thoroughly rinsed with potable water.
To disinfect food-service establishment food contact surfaces: Before using this product, food products and packaging materials must be removed from the area or carefully protected. For countertops, appliances and tables, add 2 ounces of Snap Disinfectant Cleaner per gallon of water. For heavily soiled areas, a pre-cleaning step is required. Apply solution with a cloth, sponge, hand-pump trigger sprayer or low-pressure coarse sprayer so as to wet all surfaces thoroughly. Allow the surface to remain wet for 10 minutes, then removed excess liquid and rinse the surface with potable water. This product cannot be used to clean the following food contact surfaces: utensils, glassware and dishes.
BACTERICIDAL ACTIVITY: When diluted at the rate of 2 ounces per gallon of water, Snap Disinfectant Cleaner exhibits effective, one-step disinfectant activity against the organisms: Pseudomonas aeruginosa PRD 10, Escherichia coli, Klebsiella pneumonia, Salmonella schottmuelleri, Salmonella enterica, Streptococcus salivarius, Brevibacterium ammoniagenes, Streptococcus faecalis, Shigella dysenteriae, Enterobacter aerogenes, Staphylococcus aureus, Methicillin-Resistant Staphylococcus aureus (MRSA), Vancomycin Intermediate Resistant Staphylococcus aureus (VISA) and Streptococcus pyogenes (Clinical-Flesh-Eating Strain BIRD M3) and meets all requirements for hospital use.
FUNGICIDAL ACTIVITY: At the 2 ounces per gallon dilution, Snap Disinfectant Cleaner is also fungicidal against the pathogenic fungi Trichophyton mentagrophytes (causative agent of athlete’s foot fungus, a cause of ringworm of the foot) when used as directed on hard surfaces found in bathrooms, shower stalls, locker rooms, exercise facilities or other clean, hard, non-porous surfaces commonly contacted by bare feet. Follow the Disinfection directions.
MILDEWSTAT: To control mold and mildew on pre-cleaned, hard, non-porous surfaces, add 2 ounces of Snap Disinfectant Cleaner per gallon of water. Apply solution with a cloth, mop, sponge, hand-pump trigger sprayer or low-pressure coarse sprayer making sure to wet all surfaces completely. Let air dry. Prepare a fresh solution for each use. Repeat application at weekly intervals or when mildew growth appears.
VIRUCIDAL ACTIVITY: Snap Disinfectant Cleaner, when used on environmental, inanimate, hard, nonporous surfaces at 2 ounces per gallon of water, exhibits effective virucidal activity against Influenza A2/Japan (representative of the common flu virus), Herpes Simplex Type 1 (causative agent of fever blisters), Adenovirus Type 2 (causative agent of upper respiratory infections), Vaccinia virus (representative of the Pox virus group), Human Coronavirus (ATCC VR-740, Strain 229E), Human Immunodeficiency Virus Type I (HIV 1), Hepatitis B Virus (HBV), Hepatitis C Virus (HCV), Norovirus (Norwalk Virus), Bovine Viral Diarrhea Virus (BVDV), Feline calicivirus (FCV), SARS Associated Coronavirus, Porcine Respiratory & Reproductive Syndrome Virus (PRRSV) (Strain NVSL) and Avian Influenza A. Follow the Disinfection directions. KILLS HIV-1, HBV AND HCV ON PRE-CLEANED ENVIRONMENTAL SURFACES/OBJECTS PREVIOUSLY SOILED WITH BLOOD/BODY FLUIDS in healthcare settings (hospitals, nursing homes) or other settings in which there is an expected likelihood of soiling of inanimate surfaces/objects with blood or body fluids, and in which the surface/objects likely to be soiled with blood or body fluids can be associated with the potential for transmission of Human Immunodeficiency Virus Type 1 (HIV-1) (associated with AIDS), Hepatitis B Virus (HBV) and Hepatitis C Virus (HCV).
SPECIAL INSTRUCTIONS FOR CLEANING AND DECONTAMINATION AGAINST HIV-1, HBV, AND HCV ON SURFACES/OBJECTS SOILED WITH BLOOD/BODY FLUIDS:
PERSONAL PROTECTION: When handling items soiled with blood or body fluids, use disposable latex gloves, gowns, masks and eye coverings. CLEANING PROCEDURES: Blood and other body fluids must be thoroughly cleaned from surfaces and objects before application of Snap Disinfection Cleaner. CONTACT TIME: Allow surface to remain wet for 10 minutes. DISPOSAL OF INFECTIOUS MATERIALS: Blood and other body fluids should be autoclaved and disposed of according to local regulations for infectious waste disposal. Efficacy test have demonstrated that this product is an effective bactericide, fungicide and virucide in the presence of organic soil (5% blood serum).
GENERAL CLEANING: Apply Snap Disinfectant Cleaner to soiled area with a mop, cloth, sponge, hand-pump trigger sprayer or low-pressure coarse sprayer. Snap Disinfectant Cleaner can be diluted at 2 ounces per gallon or applied at full strength. Thoroughly wet soiled surface and scrub as necessary.
DEODORIZATION: To deodorize, apply this product as indicated under the heading Disinfection.