Marlig Fix-A-Leak - 8 Oz

"Marlig Fix-A-Leak Liquid Sealant for Swimming Pools & SpasMarlig Fix-A-Leak is a blended concentrated liquid material designed to permanently seal small leaks & holes up to 1/8"" diameter in spa shells and swimming pool plumbing - quickly & inexpensively. Safe & easy to use, Marlig Fix-A-Leak has been thoroughly field-tested under various weather conditions, and has proven to be safe & extremely effective.Marlig Fix-A-Leak is also great for preventative maintenance, to coat surfaces and cut down on formation of rust & corrosion. Dosage is 8 oz. per 1,000 gallons for minor leaks; use a second bottle for larger leaks. Treatment can be repeated if necessary. Do not use in excess of 1 quart per 5000 gallons of water. Suction Line LeaksSuction Leaks are usually known by air mixed with the water at thereturn fittings. In most cases suction lines only leak water when the filter pump is shut off. Normal Circulation will simply draw Fix-A-Leak away from the leak and if the pump is shut off the material will simply not get to the leak. You must reverse the flow of water, to force the material through the leak under pressure. Preferably 5-10 psi. until the leak has stopped. When this has been achieved, gradually increase pressure to 15-25 psi. to insure a proper seal. After sealing a suction line leak it is a must to leave suction off the repaired line for no less than 48 hrs. Fix-A-Leak requires time to cure and harden.Misc. LeaksIf you suspect a leak around fittings inside the pool (such as return fittings), lights, skimmer(s) or steps, etc. Shut down pump. Apply Fix-A-Leak directly to the leak using a squeeze bottle, similar to a ketchup bottle. Allow a minimum of 48 hrs. to cure before startingup circulation.Directions (Shake Well Before Using)Bypass FILTER MEDIA before adding Fix-A-Leak to water. Sand Filters: set filter valve to recirculate Other Types: remove cartridges DEelements from filter tank. Then proceed to circulate through empty tank.With pump running add Fix-A-Leak slowly through skimmer or in front of any other suction intake.After adding Fix-A-Leak adjust suction to main drain. If this is not possible, the vacuum cleaner could be used alternatively, simply by placing the vacuum in deepest part of pool and connect to normal vacuum connection. Set filter valve to normal vacuum position.Fix-A-Leak is very heavy and will sink to the lowest point rather quickly. It must be stirred back into suspension, either manually using a pool broom or mechanically with an automated pool cleaner every 4-6 hrs. during circulation of water.Continue to recirculate water until the leak has stopped.Mark level of water in pool and check for 2-3 days todetermine if the leak has stopped. After the leak has stopped and given the prop"