Viking Electronics FXI-1 Fxs Paging Adapter
Viking's universal paging interface allows you to provide paging from virtually any type of phone system instead of from a microphone. You can also provide background music and electronic night bell over the audio system. Provides 30V talk battery for interfacing with an FXO or unused analog line input/trunk port. With the flip of a switch, the unit can connect to a FXS or PABX station ring trip port. No power supply is required in this mode. In the event that it must be connected to a "dry" 600 ohm paging port, the built-in voice activation (VOX) is in control. This configuration is useful when interfacing with systems that do not provide a paging contact closure, such as Panasonic, South Western Bell, Intertel, etc. In all modes provides normally open or normally closed relay contacts to activate the central paging amplifier equipment or connect to an external background music source. After paging, auto disconnects on CPC, busy signal, silence or default disconnect timer. An electronic night bell over paging feature can be activated from a momentary phone system contact closure (FXO and page port mode only).FeaturesSelect - FXO (loop start), FXS (ring trip) or paging port (VOX relay) interface modeNo power supply required in FXS interface modeUp to 6 units can be powered from one adapter in the FXO or VOX mode30V DC talk battery for interfacing with FXO or unused phone system line input/trunk portFloating 600 ohm paging output with volume controlNormally open or closed relay for external paging amp activation or interfacing the paging amp with an external background music source800 Hz pre-announce page tone (on/off)Compatible with 24 to 48 volt FXS operationCalling party control (CPC) detection for immediate disconnectBusy signal detect disconnect2.5 to 5 second VOX silence disconnect timerProgrammable VOX trigger sensitivity16 or 36 second default disconnect timerScrew terminal block connectionsWall mount housing - (2) #6x3/4 panhead screws includedSpecificationPower - 12-24V DC @ 100mA, 120V AC/12V DC @ 500mA, UL listed adapter included (not required in FXS mode)Environmental - 0°C to 32°C (32°F to 90°F) with 5% to 95% non-condensing humidityRelay Contacts - 30V DC@1A, 110V DC@0.3A, 125V AC@0.5AVOX Minimum Audio Signal to Activate Relay - -30dbm minimum / -26dbm minimum @ 1KHz with VOX sensitivity switch at normal / lower positionsVOX Time Out Disconnect - 2.5 or 5 secondDefault Time Out Disconnect - 16 or 36 secondsTalk Battery - 30V DCDimension - 4.38 x 2.97 x 1.38 in.
This product has not yet been reviewed. Be the first to write a review.