Plan your next getaway with SHOP Travel - Book Now!

Monoprice

Monoprice Premium 3D Printer Filament ABS 1.75MM, .5kg/Spool, Pine Green

Sold by Monoprice

Monoprice

Monoprice Premium 3D Printer Filament ABS 1.75MM, .5kg/Spool, Pine Green

Sold by Monoprice

$33.50 You Save: $18.51 (55.2%)

$14.99

$0.30 Cashback

Free Standard Shipping on orders from Monoprice. see details

Free or flat-rate shipping

Now thru Jan 05, 2019, Monoprice is offering FREE SHIPPING on all orders to the Continental US (unless additional per product charge by vendor has been add for large/bulky/heavy items. Any adjustment will show in cart and checkout)

Free Standard Shipping on ALL Orders from Monoprice!!

Offer Expires: 01/05/2019

Get outstanding 3D printing results when you use 1.75mm ABS 3D Printer Filament from Monoprice! ABS is one of the most commonly used filament types in 3D printing. It has a high tensile strength and good overall toughness. It has a...
See details

Product Information

SKU: 114372

Monoprice Premium 3D Printer Filament ABS 1.75MM, .5kg/Spool, Pine Green

Get outstanding 3D printing results when you use 1.75mm ABS 3D Printer Filament from Monoprice! ABS is one of the most commonly used filament types in 3D printing. It has a high tensile strength and good overall toughness. It has a low density and is softer than PLA, which means lower weight and lower cost when printing large models. Hardness is such that no white dot appears when bending. This 0.5 kg spool features a thickness of 1.75mm ±0.05mm. It has a nominal processing temperature of 220 ~ 260°C (428 ~ 500°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament. The negatives of using ABS is that it can give off a white smoke with a concentrated odor. It is best to ensure that the printing room is well ventilated when using ABS. Additionally, it has a high moisture absorption rate. Depending on the overall humidity level of the printing environment, an opened spool can absorb enough moisture after a couple of days that high temperature printing could cause bubbles or pocks in the extrusion. It is therefore recommended to not open a spool until you are ready to print and to store any unused portion with with silca gel and/or an active dehumidifier to reduce the amount of moisture it can absorb. Support Files: Filament Comparison Chart (180416)

Reviews

SHOP.COM Reviews

Write a Review

This product has not yet been reviewed. Be the first to write a review.